Getting Started

This article contains information about how-to proceed after installation of Xopero ONE Management Service component. It describes the process of creating an account, adding the license and going through the first setup.

Administrator account

When you open the Management Service for the first time, you will be prompted to create an administrator account. In this window you will have to provide a login (it has to be a valid email address) and a password compliant with the standards listed below the input fields.After filling out the form click the Register button, which will take you to the take next step.

Licence code

Now you will be asked to provide a license key in the next window. This is the last step before our system becomes operational, and ready to be used. Once you have registered for Xopero ONE, you should receive an email with a License code. Proceeding will redirect you to the system setups.

First run

The first setup consists of a few steps needed to be done before your data will start being protected. You should add the first device, which will be used to set up the storage - the place where your data will be stored.

To start using Xopero ONE, you have to now install the backup agent and activate it in the system.

Go to Deployment category of our knowledge base to find more details about agent installation.

And add the storage where you want to store data. Xopero ONE is multistorage software, so you can add different storages. You can use local storage (e.g. SMB/NFS) or cloud solutions (e.g. Wasabi/Amazon etc.)

Go to the Storage category to find out more about storages.

With all system components initialized, you can start protecting your devices. Start creating backup plans!